Discussion Locked

external modem wont work with WINNT

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a machine dual booting win98 and WINNT 4, external modem (3COM US Robotics) works fine in win98 but I cant set it up in WINNT 4, inserted the modem driver disk, it seems to be doing something as it shows a status bar then disappears and then prompts me to insert WINNT 4 disk into drive A: but doesnt give me the option to browse for any other dirves!! any ideas??

11 replies

by dmccabe

The driver disk I have supports win95, 98 and NT, still can't get it to work, any other suggestions would be appreciated.

by nisgoski

Get the updated .INF file from the 3Com/USR web site. Then, in the Modem tab of Control Panel, choose Add, and when presented with a list of modem brands, choose the button "Have Disk", then point to the place where you saved the .INF file. Have about 16 modens of these here, all working in NT.
Any other questin, feel free to ask.

by shanghai sam

I have had a similar incident with an internal modem. what finally worked seems not to make sense or unnecessary but ...
i had to go to the network neighborhood and delete everything: protocols, loopback adapter , and services. also remove any modems installed.
then reboot, because you have to for a sucessful installation.
when you log back in, find the executable in the NT section of the driver disk and RUN it.
you should be prompted to set up the network after the modem is installed. if not go to network neighborhood and do so. have your nt disk ready.
remember to add Remote Access Service (RAS)
and the loopback adapter.
check to see how many com ports exist in control panel/ ports. if you have none you will need to install com 1, 2, 3, or 4.
when all is (hopefully) working, run service pack 6 to update all of the files.
wish you well !

by themain

I have had a similar incident with an internal modem. what finally worked seems not to make sense or unnecessary but ...
i had to go to the network neighborhood and delete everything: protocols, loopback adapter , and services. also remove any modems installed.
then reboot, because you have to for a sucessful installation.
when you log back in, find the executable in the NT section of the driver disk and RUN it.
you should be prompted to set up the network after the modem is installed. if not go to network neighborhood and do so. have your nt disk ready.
remember to add Remote Access Service (RAS)
and the loopback adapter.
check to see how many com ports exist in control panel/ ports. if you have none you will need to install com 1, 2, 3, or 4.
when all is (hopefully) working, run service pack 6 to update all of the files.
wish you well !

by dmccabe

Hi, Thanks to all for your comments I was away on holidays so i didnt get a chance to reply, the problem has been solved, thankfully, my colleague reinstalled NT and everything works fine now. Thanks again for your suggestions.

This discussion is closed to new replies.