Discussion Locked

Failed BIOS Flash

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I support several Toshiba Tecra 8000 laptops. Recently I found it necessary to flash the BIOS from version 7.x to 9.0. The flash failed and I cannot recover. I have tried installing w95, w2k, and XP, all with no luck. I tried the original recover cd with w95, and it formats the harddrive, but it fails at the w95 splash screen. I vaguely remember there is a jumper solution, but cannot remember enough to implement it.
Can anyone help?
(Thanks to MAXWELL for directing me to this forum)

2 replies

by oz_media

It's been a year since I had a Toshiba notebook but when you FLASH a BIOS, you will always be asked to save the old file in case of a bad FLASH. Just restore the backup BIOS by running the latest FLASH again. It will list all BIOS versions saved in the computer and you can just restore the right one!

Oh yes, you don't have a backup because you've PARTIALLY restored the system right?

Open the laptop and there will be jumpers you can short to reset it. I'm told that sometimes, removing the CMOS battery does it, but I've never had any luck that way.

Toshiba will also have a complete parts replacement manual on their site, this will show you what to dismantle and how to reassemble it without pulling stuff you don't need to.

In future, the best place for Toshiba updates is from Toshiba Europe, http://www.toshiba-tro.de/
Toshiba US is behind the ball on updates.

by cg it

The Chas is the man to go to on hardware...but if you failed on a BIOS flash, you MUST have a sucessful flash to the BIOS. Not all areas of the BIOS are reprogramed during a BIOS flash therefore you might be able to go througha POST however the operating system requires data obtained from the BIOS for it to run and a faulty flash, however small will muck up this up.

This discussion is closed to new replies.