Discussion Locked

fdisk wouldn't recognize my new drive

0 helpful
17 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i was installing a second hard drive, but when i came to the part that required me to partition the new drive and make it active by using FDISK, FDISK wouldn't even recognize the existence of my new drive.

17 replies

by timwalsh

Make sure your computer's BIOS recognizes the drive. If the BIOS won't recognize it, make sure all your jumper settings are correct.

FDISK cannot work on a drive that the BIOS doesn't recognize.

by Member 32254067

yea, like the other gentlman said make sure your bios picks up the drive, if not you wont get anywhere. Check your jumper setting and then make sure you can see the drive in your bios. then you can fdsik as much as you like :)

by xpertdragon

After you have made sure that your BIOS is recognizing your hard drive, you might want to try the Setup/Utility diskette that came with your new hard drive. Often, these setup utilities have a graphic-mode setup, and are easier to partition and prepare your hard drive for a new OS installation.

If you have a Western Digitial drive go to:

www.wdc.com

Maxtor, Seagate, IBM, etc....visit their web sites for specific Drive setup utilities.

Paul

by keyboard kowboy

Depending on the BIOS, it may detect the new drive right before the OS selection screen. I prefer to go into the BIOS and use the autodetect feature, that way you know the BIOS "sees" the new drive. Also, check your jumpers and make sure they correspond to whatever IDE cable (IDE1 or IDE2 Master or Slave) you install the drive on.

by thechas

Assuming the BIOS does detect the drive, you need to tell fdisk to switch to the second drive.

To avoid problems, (and accidental drive erasure) I always set up the PC with just the new drive when partitioning and formating the drive.

Depending on the size of the drive, and the version of fdisk, it may not recognize large hard drives.
You can download newer versions of fdisk from links at www.bootdisk.com
www.fdisk.com/fdisk

If your BIOS cannot recognize the drive, the simplest solution is to install a PCI IDE controller card.
I have seen these cards selling for under $30 on-line.

Chas

by cg it

yep! yep! and yep! Question is, is the two hard drives set up as master[old bootable drive]/slave[new drive] on the same IDE ribbon cable? then as Chas said, run autodetect in the BIOS. If the drive still isn't seen, check that the ribbon cable pin# 1 [colored] is aligned with pin # 1 on the hard drive and the other end pint # 1 is aligned with the motherboard pin # 1. Check the power cables. If the hard drive still isn't detectable, I would consider the drive suspect and possibly get a new one.

by opatzg9

One other answer the above normally mention is different drive manufacturers drives sometimes will not work paired together on the same ide cable, so put one on ide1 and one on ide2. Fdisk it as the only drive would get you through the fdisking portion but you still might not see it once you'd connect the other drive back up.Good luck!

This discussion is closed to new replies.