4 replies
by pschuvie
Congratulations on your current undertaking.
While this is rather straight forward there can be a bit of debate regarding a few fine points but I won't get to far into that aspect.
Doing this install your going to have two main areas of consideration - cabling of drives and bios settings.
First the cabling - in most cases the HD would be placed on the primary IDE connection with no other device on the chain. The drive would be set, by jumper on the drive, as either Single drive, Master Single or Master depending on the instructions of the specific drive and shown in the manual or at the drive manufacturer website.
The other two CD type drives would be put on the secondary IDE bus with one set as master and the other set as slave. The choice of which to put as what is what can be debated, depending on which is faster, which is to be used more, etc. If your heavy on games using the CD then it could be master. If your going to be using the CDRW the most then it would be best to put it as the Master. Keep in mind there are jumpers on the drive that set the Master Slave setting for EACH drive.
Now that you have them cabled you would go into the BIOS and make sure that auto is set on the drive setting and that eachdrive is detected properly for what it is.
There is an additional setting that you will want to set in the BIOS which is boot sequence. On current boards you can set for A (3.5), C (hard drive) and either a SCSI device (not your case) or the CD. And you can select the order. The most common order would be A, CD, and then Hard drive.
This setup is a bit slower on boot up, a couple seconds, as the computer seeks each drive, but does give you the ability to boot from a floppy, or the CDin case you develop a problem with the hard drive.
by pschuvie
**continuing and concluding***
If you set harddrive as the first item in the boot sequence, it will boot faster unless you encounter a harddrive problem and many times such problems can prevent you from using the A or CD to boot since it never getsto the point of reaching them. But if you do strong maintenance on your harddrive, have good virus protection then this faster boot can be nice. I however, prefer the A: CD, C: sequence as it gives more options when fixing and troubleshooting etc.
So that about covers what you need to do. One last note, if your Harddrive uses ATA66/100 with a 80 strand cable make sure you put the hard drive on the correct position on the cable, as shown on the drive manual, as it is very particular about that.
Hope this all helps and clarified things.
by shanghai sam
thank you pschuvie.......
you have been of great assistance in my first undertaking of a very expensive pile of transistors assembly. for the record, the system will be composed of an FIC AD11 MB, 1.2 Ghz AMD CPU,512MB DDR Ram, w/SB X-Gamer 5.1, ATI All in Wonder 32MB DDR/TV tuner. May i contact you if i need to ask another question? Regards,Bill( wwsummers@peoplepc.com )
by wwsummers
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending