Discussion Locked

Firmware Udpate

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Can someone tell me the sets in updated firmware on a NT Server for an HP Tape drive.

I have downloaded the new Firmware.

Do you put the firmware on a floppy and boot the server up wiht the floppy in the drive and the firmware will install itself???

4 replies

by ann777

You probably do NOT need new firmware. This drive was working fine. My understanding from your previous posting, is that the drive itself is dirty or going bad.

If you have never cleaned the heads, then do so. If it has never been servicedthen try that if cleaning fails. Shine a flashlight into the drives and see if the head is worn down.

Changing firmware is for additional functionality and may totally destroy the drive. Upgrading firmware should always be a last resort, if all else fails and you literally do not care if you end up frying the device.

If you have downloaded new firmware for this device, then the instructions for doing this should also be available from the same site. Again, I do not believe that new firmware will NOT help you at all.

by ann777

Last sentence should read

Again, I believe that new firmware will NOT help you at all.

by nhoek

Ok thanks, I will avoid the firmware. The drive gets cleaned regularily. It is a referbised drive a

This discussion is closed to new replies.