Discussion Locked

Firmware

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a dell machine that is running Windows XP. I have a DVD in my machine that I had to intall new firmware for it to work with XP. However, every since I installed the firmware my mouse pointer sticks until finally it will stick and you have to hard boot to get the mouse to work again.

3 replies

by thechas

Was the firmware for the DVD drive itself?
Or the motherboard BIOS?

If the firmware was for the DVD drive itself, then it is just a coincidence that the mouse issue just surfaced.
Try getting an update for the mouse driver.

If the firmwarewas the system BIOS, then there may be a problem with the BIOS settings.

I would go through the procedure to clear the CMOS memory.
Then go into BIOS settings, and set the settings as needed.
(You may want to go into BIOS settings, and copy down the existing settings so that you can recover them quickly)
You can also look and see if USB legacy device support is set to enable in the BIOS settings. This can confuse the system if you are not using a USB mouse or keyboard.

You should alsotake a look in device manager to see if there are any missing drivers, or device conflicts.

Chas

This discussion is closed to new replies.