Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
After doing some work on my PC (upgraded BIOS, memory, video card, etc.), My power light continually flashes. Any ideas of what to check ?
5 replies
Does it still work ok?
by chipheadsr
Yea, system appears to work fine.
Would assume in that case the flashing power light is a setting in the BIOS then. Either that or you have the IDE & POWER cables mixed up on the motherboard.
by thechas
Check the hardware monitor section of BIOS settings. (sometimes in power management)
I suspect that a temperature, or fan speed is different than it used to be, and is causing the BIOS to warn you of impending doom.
If you flashed the BIOS, and did not reset the CMOS memory, that may be part of it too.
I would take a close look at the reported voltages. It is possible that you are starting to overload the power suply, and voltages are falling out of specification.
Chas
by chipheadsr
Yes, it still works ok, except you have to press the power button twcie for it to turn on. The first time it trys to startup for a second, then shutsdown. The second time it starts up fine.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies