15 replies
To be honest with you I would personally scrap the current Floppy Drive and install a new one. Their only about ?6 / $10. You cant rely on a Floppy Drive thats tempramental, and I cant see it being a software or motherboard fault.
Having said that,check in the BIOS setting to make sure that a 1.44 Floppy Drive is stated in the basic setup screen.
Hope this is of some help to you.
by launcrase
by launcrase
by peyison
Also make sure that you don't have any viruses on your system. There are a few viruses that affect access to the floppy drive.
Good luck,
by launcrase
Well there no need of installing drivers for floppy drive, check out while booting whether ur Hard Disk light is stagnant(not blinking) if yes, then uv put ur cable in wrong direction.
And there is a possibility of ur FDD Controller being damaged. Try installing a IDE Card and Check out.
by launcrase
by dmiles
Run scan disk with a floppy in the drive.
Check your anti-virus configuration to see if it is accessing the drive upon start-up and scan for virus.Check the cable to make sure that it is installed on the floppy properly that is if you have changed it lately.The floppy could be accessing because you recently used it to load and did not finish.Last it could be going out.
by launcrase
by contra-heald
by launcrase
by frankbert
by launcrase
by launcrase
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending