Discussion Locked

Floppy Drive B:\

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Does anyone remember the line that needs to be added in the config.sys, so that Windows could read the obsolete floppy drive b:??
I have both a: and b: ; I installed b: because I have to recover an important file from an old 5 1/2 disk...HELP!

10 replies

by awdfg

I don't think that you have add anything in the config.sys file to read a floppy drive.
Just check in your BIOS whether floppy drive B is enabled or not.And it doesn't matter whether it is drive A or drive B.You can make it either A or B.It dependson the connector you use to connect to the drive.On the cable the first connector is for Drive A and second one is for dirve B.

by geroxx

You may want to add a "PATH=A:\B:\C:\Widows in your Autoexec.bat.

I believe you are looking at a BIOS Issue. See if you have a bios setting for 5 1/4" drives. You may also need to cheat and put the 5 1/4 in as an A: and do what you gotta do.

HtH
Gary

by geroxx

Thinking back... I don't think that you ever "had" do add the drive in Config.sys or Autoexec.bat. It was all taken care of in BIOS.

by dmiles

Boot the system and when start-up screen appears,hit the key to enter the BIOS control panel and then under the first heading you want to make sure that floppy drive B: is enabled,then it should be recognized to use.

by electricdragon

Hi,
I come from old-dos-land so I thought I'd drop some info.
Answer number 3 is correct, I think the line to add that you are trying to remember is from earlier versions of DOS, if you wanted to copy a disk, and you only had one disk drive, DISKCOPY a: a: would give you an error message unless you had the command,
DEVICE=DRIVER.SYS ect. ect. ect.
in your config.sys file.
It is no longer needed after DOS 5.0
HTH
loren

This discussion is closed to new replies.