Discussion Locked

Floppy Drives

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Our company would like to offer floppy duplication.So we have few old 486s and a couple of p200. Is it possible to configure
several floppy drives in one box and have them all copy at the same time.

5 replies

by lo

Without doing something special, you can only get 2 FD on a system I think. There may be a 3rd party FD controller that you could add to allow a 3rd, 4th, etc. Having that you could get access to multiple drives at the same time with a batch file,scheduler, etc.

I did a DOS batch file that would loop doing format, label, pause to scratch old disks. That worked pretty good. As you have to physically insert/eject disks, this works pretty well unless you are going to get into 'large' volumes. If you are coyping a disk you can use DISKCOPY from 1 FD to another.
There is a way to get a FD image from the FD to a HD, then put back onto a FD but I forget the specifics. Flashing a BIOS does something similar I think.

by guruofdos

Professional duplicators use a hopper feed and a load unload mechanism, and have a microcontroller that literally copies the magnetic pattern from one disk to another. Doing it with a PC is a slow and laborious process. Yes, you CAN have several drives in a box, but you would need additional FD controller cards with selectable addresses. Two drives in a PC with an image on the hard disk is about as good as it gets without a lot of messing around and user interaction. The other option is to whipup some electronics using 74 Series logic IC's and have a simple Start button and a 'Finished' LED and hook one drive up as Source and multiple drives as Target. You'd need some pretty good info on the FD interface and some pretty good experience with electronics.

This discussion is closed to new replies.