7 replies
by ghimpe--
This isn't much help but you shouldn't buy a new floppy because this sounds like a software problem not a hardware one.
I had never encountered something like these so i can't realy give you a solution. Maybe answearing some question will help us help you:
Is these behaviour recently?? Did the floppy driver ever worked like it's suposed too?
What OS are you using??
You say the floppy will show the contenent of the first disk inserted even if you replace the disk. Is the contenent of the drive also accesable even if you replace the disk?? (aka is the OS making a virtual disk of your floppy)
If this is a new problem you could try doing a restore of the OS to a previous date when the floppy worked OK.
by ep_turo
by hal 9000
Well provided it did work once I would tend to think it is a software problem rather than a hardware problem. If you can answer a couple of questions we just might be able to help you out but I've never ever heard of something like this happening previously so I'm as baffled as you are.
Firstly what OS are you running and what level of patching has been done?
Did it ever work properly?
If it worked what was done to the computer just prior to the floppy displaying this behavior? Did you change some hardware install new drivers or software?
What is on the floppies and does this still happen with a Windows Boot Disk inserted? Like will it boot and then execute something from a different floppy while in DOS Mode?
If the answer to the last question is YES you defiantly have a software problem as the floppy is working properly but when the OS gets loaded it stops working properly.
Have you looked in the BIOS to make sure that it isn't set to some strange value?
Did you flash the BIOS recently? And if you did, did you follow the makers directions?
If nothing else lets know how you get on as this has me interested.
Col
by grbeckmeyer
by willcomp
Floppy drives provide changeline support that indicates when another diskette has been inserted. When changeline support fails, information from first diskette remains until PC is rebooted. That's what's happening in your case.
Fix is to replace floppy drive.
Dalton
by kewlice33
Test the floppy drive on another computer. If it does the same thing, then you need a floppy drive replacement.
If it works fine on another system, you might have some software issues. If so, you might end up reinstalling Windows.
by mad max
Of course before you go too far down the road of rip out and replace everything in sight you could check that the Floppy cable is securely seated at both ends and that all pins are engaging ( IE not bent ).
Also check cable for damage or try another known good cable.
MM
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending