Discussion Locked

Floppy: Not detected

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i used this floppy couple of days ago and when i went to open it it came up with a message saying to insert floppy into A drive. it does not recognise that this floppy is in the drive. the drive recognises other floppy disks but not this one. i have my exam notes and other important info on this floppy. please help.

5 replies

by jasonkaissi

Well, first of all, you have to make sure that this is the floppy that you had information on, since what you have could be an unformated floppy.
Now if you're sure it's the right one, you might have a corrupted FAT (File Allocation Table) on the floppy, this could be a result of a virus, or physical damage, or exposure to an electromagnatic field, which could erase data on the floppy. try the following: scandisk - anti-virus program. If no luck, try Fat repair programs such as "Easy Recovery"by Ontrak "www.ontrak.com". good luck

by maelgwyn

Ok, what you have is a bad track 0 - the disc is on its last legs. But do not dispair - help is on the way!

Thre is an ancient Norton Utility called NDD (Norton Disk Doctor - it si on the later versions, but I am only fully hersed on the old dosversion(s)). It can 'remake' the track 0 on the disc. However, any utility like these can irrepriably destroy the data on the disc - so backup to be safe (and as Unis tell you - 3 digital copies)!

Maelgwyn

by yelhsa3840

try formatting the floppy or try it on another computer with a different version of windows on it

by rcom

Yikes! don't format or attempt anything that would write to the disk. Just try to get the files off.
You may have better luck reading it in DOS.
Try to copy the entire disk in DOS mode. Boot to DOS using the f8 key just before windows clouds appear. Choose Command Prompt Only. Then type the following and hit enter. Be sure about the source and destination. The SOURCE is the disk with your important data the DESTINATION is the disk you're copying to. It may prompt you to change back and forth between disks so don't get them mixed up.
Put the disk in but don't try to change to or read it just stay on the C drive.

Type the command and hit enter. It will prompt you to insert the SOURCE disk but since its in just hit enter again.

c:\>DISKCOPY A: A:
___________________________________

Or if you can get it to read try copying files.

Commands are shown in uppercase.

First make a directory in the C drive.

c:\>MD FILENAME

then switch to that directory.

c:\>CD FILENAME

then copy the files from the floppy

c:\filename>COPY A:\*.*

by colin_mendonca

the floppy which is not recognised either has a physical damage or it has a corrupted FAT.it also might be due to lots of usage e.g. extensive adding and deleting of information everytime.i think you should try with some data recovery software only if the content is very important.

This discussion is closed to new replies.