Discussion Locked

Fopply drive not working

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I installed 2 different floppys and niether one works. Highly unlikely. I did check the boot sequence and it's fine A/C. When I boot with a bootable floppy, it skips the floppy and boots win 98. Please advise

2 replies

by schitzoid

Two thing to check are if the ribbon is plugged in correctly, as there's not a standard as to which way pin one is, like with hard drives. And second check the bios to make sure you have the right drive type and that it didn't some how get changed to the wrong type. If the drive light on the floppy is on constantly, but the drive doesn't work, then 90% of the time it's one of those two.

by backdoor man

You state neither drive works. Do you mean that neither one reads disks or are they completely dead?
If you see the LED come on and go back off during bootup, the drive is alive and properly connectly (generally speaking).
If the light comes on and stays on when the PC is powered on, then the ribbon cable is reversed.
Sometimes the light may not come on at all but the drive is still OK.
Check your BIOS. There are choices for setting floppy disk check on boot (blinks LED) and also (regarding your 2nd to last sentence) you mught check the setting for boot device order. Usually it's A:, C: but often can include CDROM, SCSI, and network device. Floppy controller chip could be bad - it's built onto the MB and replacement means new MB. Good luck

This discussion is closed to new replies.