Discussion Locked

Format hard drive

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Ho do i get a system to recognize the hard drive and cdrom after it has been format without /S, but will read the a: drive?

11 replies

by syscokid

Boot from the floppy, then type

sys a: C:

This will make the hard drive bootable, then you can install an operating system and go from there.

by richard_barsby

Hi use a bootable floppy from the operating system you are going to install, if it is win95 make sure the cdrom drivers are on it as win95 did not put them on by creating a start up disk. Now you can install the operating system from cd. If allyou want to do is make the hard drive bootable then do as answer 1 but the line is "sys c:".

Best of luck

Rich

by frescalus

Make a boot disk in Windows 95. Once the boot disk is created, reboot your computer leaving the boot disk in your machine and you should start out in Command Prompt. Then from there you should be able to reformat and install the operating system.
Neil

by zlitocook

All the answers were good but first you need to tell the bios whats there. At the main boot up screen hit the key it tells you to, to get into the bios or cmos. Go to the area where it lets you pick the hard drive and select auto. Then reboot and insert your bootable floppy disk.

by grump

Boot system form A: (If you do it with 98 boot disk soultion will be easy).
After you have booted you would type SYS C: [enter] this will place the system files on the hard drive and rewrite the boot sector on the HD. Next type COPY A:\ C:[enter] this will copy the contents of A: to C: remove the diskette from A: and reboot the computer.
You can now install windows on the HD.

If you are doing WIN95 you will need the CD ROM drivers.. Try to get 98 boot disk and follow the above procedure. You can still install windows 95.

Good Luck..
Grump

This discussion is closed to new replies.