Discussion Locked

Garbage characters display on PC bootup

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I had a power supply that just "blew out" one day after plugging in the power cord, I saw a little smoke so I decide to remove the power cord and replace the power supply.
I hook up the power supply correctly and I when I press the power button thePC it boots up very well but on the monitor garbage characters are being display, but I can hear the hard drive and everything spinning as if working fine.The garbage characters apparently have replaced the normal characters as you can still make out "in form only" the energy symbol that comes up on startup(in color too). It is a Pentium 3 system. I don't know where to start to diagnose this problem. Please help.Thank You!

8 replies

by opatzg9

Well it sounds like a little more may have burned up than just your power supply. About all you can do change out piece by piece. I'ld start by seeing if a different video card would work if you have a spare around or know a friend with one(a spare). If the change of video card brings back normal characters then maybe just the video blew out. Otherwise start considering a motherboard/cpu replacement. You can check bios and see if the language somehow changed, changing it back may be difficult when trying to read chinese or sanscrit. How many of your peripherals are built in to the motherboard? If you have integrated everything, I'ld start looking for the motherboard/cpu replacement option. Good luck!

by opatzg9

Depending on the number of additional cards in the pc, I'ld remove all except those you need to see whats functioning correctly, video ide controllers. Remove network/modem/sound,... There by limitting what may be causing any problems and start diagnosing from there.

by cvchristensen

Check your video cable first, it may be loose. Next, try to change your video card with a "known good" one and reseat your memory. I really don't think that it is your CPU or System board. If either of these had failed you would not see video.

by thechas

Depending on how the power supply went out, it could have sent a high voltage on any of the power lines.

Take a look around the voltage regulator section of the motherboard.
You are looking for bulging capacitors, or burnt components.

If you have (and know how to use it) a voltmeter, you can check the output of the voltage regulators.

Most likely, the motherboard is damaged, and the CPU and RAM are questionable.

I would test the plug-in cards, RAM, and CPU 1 at a time in a known working system.

If all test good, then the motherboard is the likely bad part.
If several of the other parts are bad, I would still consider that the motherboard is likely damaged, and could damage ANY device plugged into it.

Chas

This discussion is closed to new replies.