Discussion Locked

Gateway 2000 SOLO 9100 sound problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Recently upgraded to Win98 2nd edition. I lost the sound. Have tried upgrading drivers in device mgr; tried changing irq's in device mgr. keeps grabbing the printer port irq, if any (irq-7) After the upgrade, detected MS-Windows compatible sound system and Sound blaster contoller or compatible.

5 replies

by robert young

Firstly check in your control panel settings that the sound is enabled. Then check your IRQ & DMA settings. If you could send me a screen grab of the settings then that would help a lot to finding out what possible problems there are.
mail to administrator@kinloss.screaming.net.
I suspect that Windoze98 has tweaked your IRQs etc the wrong way.
Regards
Robert Young

by robert young

Firstly check in your control panel settings that the sound is enabled. Then check your IRQ & DMA settings. If you could send me a screen grab of the settings then that would help a lot to finding out what possible problems there are.
mail to administrator@kinloss.screaming.net.
I suspect that Windoze98 has tweaked your IRQs etc the wrong way.
Regards
Robert Young

This discussion is closed to new replies.