6 replies
by parbo
I think you mean it didnt get an IRQ. If so this is what happens.
Your system has limited IRQ's available. It comes with 16 but some are used by the system. If you go to device manager and double click on computer it will show you what irq's are being used. When you put in a device like a plug in card windows will try to give it an irq and mem address (plug 'n play) If there are no available irq's windows cannot give anything out or maybe it requires an irq that's being used by a different device. sometimes plug in cards have a preference. So start from basic without all other cards and put in you controller card first and work your way up again until all cards are back in without errors. Some bioses also have the ability to specify how irq's are shared: auto, 1, 2 or 3. If its set to auto you night want to change it to 3,save and reboot.
hope this helps a bit
by william jay
The AT IDE spec allows for four IDE controllers to be present in a given system. Most of the intel/windos machines are setup for two, on the motherboard, both enabled by default. Many motherboards allow hard and/or soft jumper configuration for the devices attached.
From the question arise a few questions.
Why use all capital letters?
How many IDE devices, (hd and cd drives), do you want to install on how many controllers?
Are there any SCSI devices installed?
It looks like you want to upgrade the IDE busses by putting in a more capable controller, on a PCI card. If so, the built-in IDE services on the motherboard may need to be disabled for the card to get the expected IRQ and memory configurations. Go into BIOS setup: disable primary and/or secondary IDE, as required; enable PCI IDE for off-board devices; turn on features specific and desired, turn off those conflicting or un-desired; auto detect hard disks again, and hopefully --> save and exit, zoom zoom, windows boots and detects new hardware and away you go. However:
PCI slots in some motherboards are hard-wired shared, so when a device is installed in each, both get the same IRQ. The remedy is to move the card(s).
Some devices require a dos boot without memory managers to set or reset thier NVRAM, (settings that stick through power off cycles), or to initialize properly after removal of the card from a system. Have the disk with utilities handy, boot to command prompt, and apply the setup program.
There are other things to look at if these suggestions don't get it going, so please post a comment with a few more details and we can nail it sooner.
**Look carefully before assighning anything to a system expected/protected IRQ, (0,1,2,3,4,8,13,14,15).
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending