Discussion Locked

Gigabyte GA-8PENXP POS Reporter

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Does Anyone Know How To Make The Gigabyte GA-8PENXP Post Report You Can Make It So It Speaks During POS-POST When The Case Is Open And So Fort I Just Dont Know How The Website Of My Board Is
http://www.gigabyte.com.tw/MotherBoard/Products/Products_Spec_GA-8PENXP.htm

Thanks If Anyone Can Help I Only Got 50 Points Left Sorri Otherwise I Would Make This A 100000 Question BUT PLZ HELP THANX jUst-Ice

3 replies

by thechas

Just to make sure that I understand what is going on:

When you boot up the PC, you get no POST screens.

When you boot up with the case open, you do get a POST screen.

If that is correct, I suspect that this is a feature of the motherboard.Gigabyte decided to set the BIOS to a "quiet boot" mode when the case switch is in use.

Like you, I see no option in the manual to enable POST at boot.

Looking over the description of the case open switch, I suspect that the only way to get a POST screen is to leave the case switch disconnected.

If my assumptions are wrong about what is going on, just let me know what is going on.

Chas

by dualinlinememorymodule

NONONO What I Mean Insteed Of Stupid BEEP BEEP BEEP

The Motherboard Speaks To You Its Like

"Now Loading Your Operation System"
Etc...
I Cant Remember How To Make It Talk To Me And It Can!!!

Understand Me Thanx Mate

This discussion is closed to new replies.