Discussion Locked

Half duplexing Intel Network Cards

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do you get Intel Pro 100+ cards to accept half duplex? At my place of employment we are trying to get these cards to go to half duplex, but everytime we do select half duplex upon rebooting the system tells us that the card settings are wrong and will not connect to the network? Any clue as to what we are doing wrong?

7 replies

by grooverr

Either you haven't set up the add/remove hardware or your IRQ's are conflicting. Go to device manager and check resources.

by ebob

It sounds like the NIC is saying "I am trying to talk with the network but the network does not want to talk to ME!"

Obviously you've confirmed that the hub/switch into which these boxes are connecting are also set to 1/2 duplex. I ask because sometimes your network boxes are set to "auto". Auto works only sometimes, so you can hard code this, at both ends to force the issue.

by bowieb

Check to make sure that you also have the speed set correctly for the card. If you manually set it to half-duplex, you also have to manually specify 10Mb/s or 100Mb/s.

I will also second what eBob said. Check your switch and manually set it forhalf-duplex as well.

This is actually the easier way to do things. You may even want to leave the cards set to auto and just set the switch to half-duplex. That is the way we have things configured at our office and the Pro100 cards work fine.

This discussion is closed to new replies.