7 replies
by jereg
The best place for this information is the hard drive manufacturers. You did not indicate a specific drive maker, so you may want to check several sites. I wrote a paper for college several years ago, and found more information than I needed at these web sites. A good one to start at is Western Digital. There's enough there to keep you busy for a while.
http://www.westerndigital.com/acrobat/
Good Luck
Jere
by jai077
by buffalodan
A hard disk is an analog recording device, analogous to, but not exactly like, recording to an audio tape.
So, essentially, data in the form of ones and zero's is being written to, and read from, an anolog device.
This requires an encoding method.
Digital data is encoded into an analog format for writing, and decoded from analog, back to digital, when reading.
The most popular encoding method in use today
is RLL (run length limited), in which the run length of a data field is read, electromagnetically, as a lack of transitions of voltage. meaning, a data point is set as 1 or 0 by the transition from one voltage level to another...and continues as that same digital value (1 or 0), until the next voltage transition is registered.
One generally assumes that +5 volts is equal to a digital one, and a voltage of 0 volts is equal to a digital 0, this is not the case when encoding and decoding data from a hard disk.
The drive might register a transition from 0 volts to 5 volts, which is read as a digital 1, and thsi transition might last for 5 milliseconds, and this could be read as 5 digital 1's in a row, followed by a transition from 5 volts to 0 volts, read as a digital zero, and this voltage level might last 2 milliseconds, and be noted as 2 digital zero's in a row.
The transition of voltage levels, followed by the running length of the magnetic field is what is being measured here...
Are you sufficiently confused, so am/was I, and it has been many years since I studied Hard disk theory, (1987 to be exact), and I may have made a mistake or 2, but this is generally the gist...
Mind you, this is mostly useless information....
For greater detail, I might also suggest contacting Steve Gibson of Gibson Research, his web site is : www.grc.com
He is a system engineer, (And a decent guy)who was deeply involved in developing HDD encoding and decoding methods for many years....
by jai077
by jai077
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending