Discussion Locked

Hard disk help

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

hi.

I need to get data back from my hard disk,a maxtor D740X.I've just got a new hd,a 120gb so i placed the d7 as slave.I damaged it ,dunno if the bootsectors and so on or if it's a mechanical damage ..plates?..,when i was holding it in my hands and the power cable came off..i heard some clicks and then **crash**.So now the situation:when i connect the hd(the settings are correct !),the bios doesn't recognize it,and i hear those damn clicks and strange sounds.I have also freezed the d740x but no way:what may i do?consider i MUST get that files back and i don't want to shell out the money professional people asks for the job.
P.S-> if(!DATA&&!HD)suicide();

7 replies

by thechas

It depends on how important the data is to you.

If it is crucial data, you are best of to stop where your at, and contact a recovery service.

The less you do to the drive, the easier, and cheaper it is for the services to recover the data.

If you wish to try yourself, start with the TR Download "200 ways to revive a dead hard drive"

It sounds like the actual drive controller electronics on the drive may be damaged.
If you want to give it a try, you can swap the controller (circuit board on the bottom of the drive) with an identical drive.
I don't know if Maxtor uses a common board for a family of drives, so I would play it safe, and use only the board from an identical drive.

Make sure to wear an ESD ground strap when swapping the drive controllers.

I know that on some drives, some of the connections from the controller to the heads are soldered. If your drive has soldered connections, please have a trained solder technician perform the controller swap.

Chas

by sparky123456

Thats harsh
The clicking sound is probably the read heads crashing into the platters. You can try entering in the hard drive specs manually into the bios - I actually saw this work once. If the vacuum seal is damaged on the drive then you have a problem - you can try putting it into the freezer for an hour or so them quickly put it in the comp and boot up and it may work for a few minutes...

by csmith

The clicks you are hearing are a seek problem.
The drive electronics may not be reading the disk(platter), or the disk is not spinning.
This is a serious problem, but the fact that the IDE controller on the MB can not see the Electronics indicatesthat this is an electronic problem, not a mechanical one.
HDs do not normally fail from a spindown during a read, unless they are moved during the spindown.
IF this was the case, there would be a lot of HD sales everytime the power went out.
You are seeing the value of data, and the reason tape backup drives are still sold.
You have done everything short of replacing the controller board on the drive, and it looks like that is what is necessary.
Swap the controller board off of another D740X.
It is not hard, just be carefull not to damage it.
Regards, Chris

This discussion is closed to new replies.