Discussion Locked

hard disk not detecting

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have one hard disk 6Gb. i have an important data inside now when i conect hard disk to my computer it doesn't even detect at all and creates sound while system is plug in. so how to have a back up for the data ? thanks if you can help me.

5 replies

by dmiles

The drive is on the brink of going out and you may be able to save the data by freezing the drive and then installing in another machine and transfer the data to the good hard drive.
If you have Norton disk doctor available it may be helpful in saving the data. Good Luck

by uellem

Is it on a Master/Slave setup? Check the settings on the hard drive to make sure the jumpers are set right.

Just one hard drive on the computer? Change some settings on the BIOS--like changing Primary HD settings to Auto/Auto. If that doesn't work, try specifying the actual hard drive settings by choosing User.

You may also want to try the hard drive auto detection option from the BIOS.

Otherwise, just freeze your hard drive (no joke) and try installing it again. [Remember to put it in a ziploc bag first so it doesn't get wet.]

This discussion is closed to new replies.