Discussion Locked

hard disk space recognising

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Dear Sir/Madam

I having 4 GB seagate hard disk, using this, i had installed windows 98 from dos, the
partition is fat32, but it recognising only
2 GB, how can i get the remaining 2 GB,
requesting you to give me the solution

Thanks and Regds
Manikandan.V
India

7 replies

by jwilczyn

1.Boot to DOS prompt or restart from a bootable floppy (the same OS as on HD) with "fdis.exe" on it.
Run "fdisk" - the fdisk will ask you to enable large disk support (you can read there explanation why to use FAT16 -max2.1GB or FAT32) and create 2nd partition.
After restarting PC you will be able to see 2nd HD. Go to properties of 2nd HD and format it.
2.If you want to have one partition 4GB - you will need to reinstall OS. But 1st run ?fdisk?, enable large disk support, delete partitions and create big one (4GB). Restart PC, format HD and then start installing you system.

by big ray

There should not have been any problem with fat32 recognizing the entire 4 gig. Did you use fdisk to create the partition before installing windows, or did you use the windows setup to create the partition? either way, get powerquest's partition magic. It will allow you to extend the partition to the full 4gig without having to reformat and reinstall the OS.

This discussion is closed to new replies.