Discussion Locked

Hard Drive

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I purchased a new computer for my mother in law and it has a 40gig HD WDigital. Her old pc has a 13gig WD HD and it has her documents and and tons of pictures. I tried to set it up as a slave with new pc and it is recognized in the bios but when I get into windows and look into my computer it's not there. I tried several different jumper settings too. Still nothing. Can anyone tell me what's going on?

8 replies

by rapidad

First tell us what your(her) new Operating system is and what was the old one. If the new os is W2K the go to start/settings/controlpanel/admin tools/computer management/disk management.....
tell us if the system sees the old drive in disk management and what it says about it.
By the way the old drive wasnt compressed was it??? let us know

by thechas

1. Make sure that you set the jumper on the 40GB drive as master. Most WD drives require different settings when used as a master with slave present, as oppossed to a single drive.
Also, system mfgs are going back to cable select for hard drives.
If the IDE cable has a hole in part of it, it is a cable select setup, and your jumpers must be set to cable select on both drives.

2. Is the drive setup in BIOS settings the same way it was setup on the old PC?
If LBA mode was enabled on the old PC, then it must be enabled on the new PC.
If any of the drive paramaters are different, Windows may see the drive as not being partitioned.

Chas

by rezrider

Oh yea I forgot to mention that both drives are win98 sec edition fat32. The data is not compressed.

by exp

do you know if your old HDD has any device drives like Ontrack disk manager etc. They were popular some years ago to overcome the 8Gb barrier. If you have then you have to do the transfer thru a network or direct cable connection.

This discussion is closed to new replies.