5 replies
by csmith
This message comes from setup.exe in Win98 not from fdisk.
Set up the BIOS to boot order A,C .
Check the HD settings in the BIOS.
If LBA and Large don't work, try Normal and manually enter the Cyl. Head and Sec. off of the drive lable.
The size display will be garbage, but I have had to do this with some drives, (Particularly Western Digital) and it works.
Boot on the Win98 floppy and enter the fdisk
command.
After selecting FAT32 and creating the partition, reboot on the Win98 floppy and give the PC the, format C: /u /s ,command.
That should make the HD ready for the setup command.
Regards, Chris
by ddaniel428
by acosgrove
If you're using the Win 98 Setup Boot Disk, when the computer boots with the floppy in it gives you 3 options. Start setup, boot with CD support or boot without CD support. Chose the third option (boot without CD support) and this will bring you to an A prompt. type FDISK and say yes to enable large disk support. Before continuing, select option 4 from the main fdisk menu to view existing partition information and verify that there are no partitions currently on the drive. If there are not, press escape and choose option 1 to create a primary partition. This will setup up the c drive. once this is done, you will have to reboot to let the computer recognize the changes. When you reboot, you can either go right into Win 98 setup andlet that format the new partition or you can select boot option 3 again and format it yourself. Either way you do it this should work.
Good luck
by ddaniel428
by ddaniel428
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending