Discussion Locked

hard drive

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

how does my hard disk is detected at the start-up but when im in dos mode or im in windows i cannot see niether access my drive?

what is the problem of my hard drive?

how can i fix it?

what utility can i use to fix it?

how can i revive and retrieve my files on my hard drive?

6 replies

by csmith

This symptom can have several causes.

The most likely software cause is a virus.
To check: Set Bios to boot order A,C .
Boot on antivirus floppy, and scan for viruses.

The most likely hardware problem is a bad battery, followed by a failing hard drive, or a loose IDE cable.

This is the place to start.

The problems that are next most likely, are all under 5% probability.

There is an autodetect IDE utility in the BIOS.
If the BIOS settings are wrong, definitely check the battery.
Regards, Chris

by csmith

If the Partition Table or the Master Boot Record are corrupt, check for a failing hard drive.
The mbr problem can be bypassed with a DOS command, but to recover data when the Partition table is corrupt, you need a commercial utility.
This incidentis a good example of why important data must be backed up.
Regards, Chris

by acosgrove

Another possible cause is that the Partition Table has been destroyed. If this is the case then any data that was on the drive will be gone. To check this, boot to a bootable floppy which has FDISK on it. Type in FDISK and select option 4 from the main menu (Display Partition Information). This will list all the current partitions on the drive. If there are none listed, then you will have to create a primary partition and format it. Unfortunatly, all the data will be gone. The fact that the BIOS sees the hard drive leads me to believe that it's plugged in properly and it is getting power. If you get a DOS prompt and type in the drive letter (say c:) and it says invalid drive specification then the drive is either damaged or not partitioned. Good luck.

PS If this is not the primary HDD, then you will have to select option 5 in FDISK (Change current fixed disk) and select the HDD which is giving you the trouble.

This discussion is closed to new replies.