Question Locked

Hard drive

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I Just installed a new hard drive in my optiplex gx110 and it does not detect the new hardware. what do I need to do to get this working? There is no operating system on it yet and I'm trying to get to where I can install one.

3 replies

by meridenscrafts

What kind of windows os system did it have on it? YOu can try a bootdisk, Go to www.dogpile.com and look for fdisk, Format the hard drive. Then put your floppy disk or Cd in and It will find it and install your os system. Most Hard Drives have to be formatted to start with. Be sure you use a format disk with the os system you plan to use

by thechas

When you say it does not detect the drive, do you mean at the BIOS or Windows level?

Unless the BIOS was hard set to your old hard drive, it should auto-detect the new drive. If the new drive is the only drive, you will get an error message about no operating system found, insert disk.

In order to use the new hard drive, you need to partition, format, and install an operating system on the drive.

Now, if you are adding this as a second hard drive, all you need to do is go to the Disk Management option of the Computer Management option under Windows Administrative Tools.
(Assumes XP)

There you can partition and format the drive.

For either of the above, if the BIOS does not detect the drive there could be other issues. Start by making sure that the specific IDE channel is set to auto-detect. Then, check cables and jumper settings on the drives. With 2 drives on one cable, one needs to be set as Master With Slave, the other as Slave.

Chas

This discussion is closed to new replies.