Discussion Locked

HARD DRIVE CABLES

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I HAVE SEVERAL HARD DRIVE CABLES SOME ARE SUPPOSED TO BE ULTRA DME ATA IDE 33/66/100/133
THE OTHERS ARE STANDARD CABLES. HOW CAN YOU TELL THE DIFFERENCE? 2)HOW CAN YOU READ THE NUMBERS ALONG THE CABLE TO IDENTIFY? I KNOW THE DIFFERENCE BETWEEN IDEAND MFM. ?HOW CAN YOU READ THE MEMORY CHIP NUMBER TO IDENTIFY WHETHER IT IS PARIT, PCI OR DDR? I NEED DETAILS HOW TO READ THEM.

9 replies

by thechas

For the IDE cables, look closely at the ribbon cable itself.
The ATA/UDMA 66/100/133 ALL have 80 conductor ribbon cables.
Cables with the 40 conductor wire are rated for a maximum of UDMA 33.
There is no 'reliable' way to tell if a cable is 66/100/or 133 rated.

As to the RAM, yes, you can tell what type it is by the part number.
However, you need to find the data sheet for the memory IC from the manufacture. This is not always easy as many IC manufactures only use a logo, and not the company name.

SDRAM and DDR DIMMs are physically different.

DDR DIMMs have a single notch slightly offset from the center of the DIMM.

SDRAM DIMMs have 2 notches.
1 is near the center.
The other is between pins 10 and 11.

RDRAM (Rambus) is a different pin count then either DDR or SDRAM.

For all types of DIMMs, you need to locate either the DIMM mfgs, or the IC mfgs data sheet to identify the 'rated' speed.

There are test programs that you can download to verify what memory you have.
One source is www.vml.co.uk/

Chas

by maggot

just a suppliment to ansewer #1. with reguards as to parity and non-parity modules. count the number of chips on both sides of the module, if you can divide that number by three it's parity.
you can still run parity memory on a non-parity
supported board, it just ignores the extra data bit.

by wlbowers

ata100 and 133 cables have a blue connector
on them. Aka the blue connector on the
mother board.

The numbers along the cable are not a good
identifier because it is usually the ribbon
cable's identifier not the hard drive cables.

MFMis the oldest hard drive interface. Unless
you have an old IBM PC. I doubt if you will ever
need it.

With the other answers this should help.

Good Luck Lee

This discussion is closed to new replies.