Discussion Locked

Hard Drive Crashes !!!!

0 helpful
16 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i`ve network of 50 computers but within month 7 hard Drive crashed - is there any tool to discover the cause of problem on network basis-is it any virus? or any application causin this problem? any tool to discover the cause of problem , b4 it happens - all harddrives r less then year old & westren digital.

16 replies

by dimorphic2006

Interesting question. I was wondering if you could give me some more info about the type of HD you are using & in what enviroment. I've seen this problem before w/ SCSI drives & people not terminating them correctly.

by reeree

It could be a virus. The first thing I would do is go to www.westerndigital.com/support/
and download the diagnostic utility. The next time (or now if you have one) would be to boot to this disk and check out the hard drive. This utility will tell you if the hard drive is bad. If the HD is still good then I would assume you have a virus on the network. Be careful with this utility, there is one test that will wipe out the information on the hard drive. But, it will either re-certify the hard drive (it's good) or tell you it's bad. If it is bad you should be able to return them. most come with 3 yr warranty now.

by reeree

Well, if it is a virus, it's on a computer. Update the DAT files for the anti-virus and scan all files. Hopefully you are only running one version of the anti-virus on the network and if you have the capability you could push the update to every computer on the net. Otherwise I guess you or someone else should visit each computer on the net. You could put the update on the server but, what are the chances that every single user on the net will do the update and do a complete scan?

by william jay

Take alook at the installation of the drive itself too. With the cover off and the machine upright, (oriented as operating), look to see if the case is up, the drive electronics are up, or the drive is mounted on it's side. Drive Electronics up willeventually fail as the drive gets full, bedause it is mounted upside-down.

by ebob

All very good suggestions. Also, check your environment, especially POWER. Have your electrician put in a monitor to make sure that the voltage and frequency are within tolerances. Also check to make sure your PC's power supplies are toggled to the correct setting (typically 120VAC/60Hz or 230VAC/50Hz).

Hmm, as I mention the PSU in the PC, also make sure that the PSUs are up to spec. Depending on where these systems come from, the builder may have scimped on the PSU. Most modern PCs need at least 250W. Much more if you're running lots of fans, CD/DVD type drives, more than one or two HDs and/or a FDD and ZIP/Tape.

by sabirkhan

all really good suggestions but how i can discover that there is a virus on whole network as antivirus run on individual computers - any utility ????

by tocolote

If they're brand new computers the cables can become loose in shipping. Open every new computer and check the connections on every power and signal connection. This happens all the time and it won't be a problem until the customer moves the computer when you're not around.

Check the power wiring. Get one of the electric checkers that show if the power lines are reversed AND if the ground is good.

You can rent power monitors that will print out fluctuations in voltage and current if this gets worse. Brownouts can cause this problem (Can you spell coffee pot or microwave oven?).

Check with the hard drive manufacturer. Send them an email complaining about your lack of satisfaction with their hard drives. If someone else is experiencing the same problem it could be a manufacturer error.

Use a professional hard drive utility to thoroughly check out the hard drive. Not the utilities that come with Windows, they're not good enough to find some problems.

The last option might be a virus. Sing loy.

by vivisector

What kind of crash are you having, just a wipeout of data, or the infamous clunk-clunk. Were the machines purchased around the same time, as I have seen many instances where a bad batch of computers went out, and eventually we had to replace failing components in entire batch. IE Compaq's failing Bigfoot drives, or IBM's faining cache on the 300GL's. Contact the place you purchased them from if they were all purchased at same time, and see if there is a recall on the hdd's. You may get themall exchanged before you run into problems with the others.

This discussion is closed to new replies.