Discussion Locked

Hard Drive Fails After Backup tools

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have 2 Hard drives, the master(C) has Windows 2000 Pro, the slave(F) has Windows ME, I started a Backup using the Backup Tool of Window 2000 pro,then the computer Shut Down itself, after that the Slave Hard Drive is not recognize in the Bios, during boot up I get a message saying:Primary Slave FAIL, I go to the Bios trying to set up manually cause the system does not recognize it anymore, Can you tell me what is wrong and How can I fixed it. Also, whe I was doing the Back up I selected ALL files Including the system data, I am not sure If I erase the partition or Master boot Record.
Thanks

3 replies

by djent

Sounds like a physical connection problem, try contact cleaner/new cable.

by thechas

It is possible that your slave drive choose that moment to fail.

When BIOS does not even recognize a drive, that usually means that the electronics (controller) on the drive itself have failed.

If you are fortunate, it is possible that either the power or IDE cable has come loose from the drive.
Or, a jumper is not making contact and the drive no longer knows that it is supposed to be a slave.

Chas

by otl

Had a HD that failed in the same manner, warning signs I did not heed (progressively slower access times/intermittant read failure). In the middle of opening a file it decided it was a paper weight, not a HD. Still can not get into it (brand name excluded), numerous problems with this type of drive (home/work), read, write, and imminate HD failure.

Master Boot Record will not stop it from being detected in the BIOS. Thus try changing it to master, if still not detected by the BIOS then HD died. If BIOS detects and you can boot up, back up files ASAP as it may not last.

This discussion is closed to new replies.