5 replies
by thechas
Well, you can, BUT don't get your hopes up too high.
First, I assume that you do not have a clean room environment. So, the platters have become contaminated just by your opening the drive.
Close the drive back up right away.
Second, the loose head may well have damaged at least 1 side of 1 platter.
Depending on how valuable the data is to you, the less you do yourself, the easier it is (and thus lower cost) for a data recovery firm to recover the data for you.
If you desire to attempt a repair, here are some guidelines.
Short of a clean room, choose the cleanest space you have and seal off any forced air vents to the room.
Clean the work surface, ceiling, tools and nearby items with water.
Use an ionized air (anti-static) blower to help keep any free dust particles from sticking to the platters.
Wear a face mask, clean room grade latex or cotton gloves and an anti-static wrist strap. Along with the most lint free clothing you have.
Handle the platters VERY carefully so as to not bump into the heads, or touch the actual surface of the platters.
Best wishes,
Chas
by bfilmfan
Not that I am interested in points as Chas was 100% correct, but I do want to know if you had considered ever backing up any of that critical data onto a portable USB hard disk?
That would have saved you a ton of pain that I am sure you are about to experience.
by wjmcmanus
Thanks, but no I didn't back it up. I did buy a 40GB Mobile Disk today...perhaps this answer would have been acceptable had I asked, "how can I save myself a ton of pain?"
by willcomp
here's a link to a reasonably priced data recovery company. As Chas stated, the less you do yourself, the better the odds of recovering your data.
Dalton
by wlbowers
Here is your current problem. That drive was assembled in at least a class 1 clean room.
This means that the contamation in the air is less than 1 particle .5 microns in diameter per cubic foot.
To put this in perspective. Pollen is 50 microns, human hair is 120 microns. Normal fresh air contains over 1 million particles that are .5 microns or larger per cubic foot.
The drive heads travel at @.05 microns above the platters. Some drive actually use a lubricant to keep the heads from crashing because the distance is so close.
Contact a recovery service.
http://www.iomegadatarecovery.com/
Tell them the story and go from there.
Good Luck
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending