Discussion Locked

Hard-Drive for CTX Ezbook 700 Series

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I had to format the hard-drive on the CTX EzBook 700 Series. After the hard-drive was formated and I rebooted the notenook ready to reinstall O/S(WinNT 4.0), it's telling me "Invalid system disk-Replace the disk, and then press any key!" I've donethis on numerous occasions and never had this happen! I've tried several different boot disks but nothing seems to work. But when I removed the hard-drive it would give me an A:> But of course I could not do anything with out the hard-drive! So basically is this hard-drive toast! Or is there something I can do that will allow me to load the O/S?

Thank U!

Kenny W

8 replies

by cajundon

Hi Kenny,

What disk did you use to format your hard drive? Did you use the bootup disk of WinNT 4.0? Did you format the hard drive with the "format /s" switch? Is your BIOS recognizing the hard disk? Set it to Auto in your BIOS.

If you formatted the hard drive with an older verison of Dos, WinNT will not recognize it.

Please post me a note here, with what iformation you can provide, so we can get the hard drive working again.

Good luck, and have a great day.

Don Thibodaux, Computer Technology Consultant.

by woodken23

Thanks Don!

Here are the answer to the question you asked me. I did use the boot disk from WinNT 4.0. Also I did format the hard drive with "format/s". Plus what strange is that in the BIOS it does recongnize the hard drive.

Kenny W

by roberwel

Another thing you might have is in the motherboard bios there is sometimes a boot order. make sure you have it set to A first when booting from the floppy.

This discussion is closed to new replies.