Discussion Locked

hard drive installations

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
how can I make my Award bios v4.51 recognise my new maxtor d740x-6L 40g hard drive and install win 2000 pro in a primary drive,with a 6.4g removable hard drive to be used as a separate drive also with win 2000 pro.

5 replies

by dmiles

First you will need to check the Motherboards manufacturers web site to find update for the Bios,then follow the instructions to flash bios update.
Open the cmos panel by pressing the designated key and the check the configuration for drives is setto Auto
Now insert the cd-rom and run setup using the clean install option and not the upgrade,then you should have the second drive set to slave on the IDE controller and run setup as a clean install when prompted for installation partition

by thechas

Does the Maxtor require different jumper settings when used as a single vs. a master?
If so, make sure the removable is on a different channel than the primary.

If your MB does not recognise large drives, you may need to use the bios overlay software from Maxtor.

Another option would be to add a drive controller card to your system. If your MB does not recognise a 40 GB drive, I suspect that it has ATA33 or slower drive transfer speeds.
A new drive controller will support either ATA100, or ATA133. This will give you a significant performance boost. Well worth the $30 - $50.

This discussion is closed to new replies.