Discussion Locked

Hard drive is okay

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My brother's hard drive from a Tiger was getting major registry and dll file errors. I brought it to work and reimaged it and booted it up with a Compaq deskpro. No errors. Ran great. Booted back up to the Tiger and errors galore again. This is not a hard drive issue??? What could it be? The drive is the stock for the tiger and ran fine for 3 years.

9 replies

by richard_barsby

Hi I'm not sure if this helps but you can get this sort of error if the main clock speed has been increased ie if the front side bus is 100MHZ some boards allow increasing this this causes all bus speeds to be increased including the ide ports whichcan cause corruption of the HDD.

Best of luck

R.K.Barsby

by fgarber

You can also get this kind of problem from a flakey disk controller. I would try a new ide controller first.

by grantcom

If the registry errors are of the boot up type then the likely culprit is bad RAM. Try changing out the RAM this should solve the problem

Good luck

by geroxx

All of the above are good to check but also check your P.S. It has happened to me. I was getting all kinds of file errors, BSOD's, and corrupt data. Tried everything then a friend who owns a PC store gave me a P.S. I installed it and it worked like a champ.

I then messed with the old P.S. and it looked good with a voltmeter. When I checked it with a Oscope I noticed that there was about 25mV of ripple on the 3.3v output. I also hooked up a chart recorder and let it run for about 20 minutes... It looked good for 15 minutes but I saw a noise spike that intermittently occures.

So bottom line... You can't always see a bad P.S. with a voltmeter alone.

HtH
Gary

This discussion is closed to new replies.