7 replies
by thechas
If this is a new drive that is not partitioned, you need to open Disk Management and partition the drive.
Control Panel
Administrative Tools
Computer Management
Disk Manager
Next, it is possible that the drive has drive overlay software installed.
This is a common work-around for drives that are larger than the BIOS can recognize, or if the drive was setup using the drive manufactures installation floppy.
Drive overlay software MUST be installed on the boot drive to function.
You can usually remove drive overlay software by running fdisk with the MBR switch (fdisk/mbr).
Keep in mind, that removing any drive control software may make the data on the drive inaccessible.
I would start by running disk manager, and seeing if you can delete and re-assign partitions to the drive.
If so, you can format the drive directly from disk manager.
Chas
by molmsted2421
by johngreer
Has the "new" hdd ever run as a 2nd hdd before?
If not, you will have to play with the small jumpers on the drive to mark it as a slave, the default is master (and Windows only recognizes one master.)
by molmsted2421
by molmsted2421
by molmsted2421
by molmsted2421
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending