Discussion Locked

Hard Drive not recognized with 2 drives

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
On a Gateway 700X, using Win XP Home, with a 80GB IDE hard drive, I installed a second 40GB IDE drive a few months back. Both drives are Western Digitals and all has been working fine until this week. Earlier I powered off the computer and then the next next powered on. The system wouldn't boot. It wouldn't recognize ANY drives. I tried swapping cables, re-seating, but nothing. However, if I just disconnect the second(slave) drive it boots fine. If I reconnect the second, again no drives are recognized. Any ideas appreaciated since this environment has been working for months until now.

9 replies

by thechas

Start by double checking the jumpers on the drives.
Most WD drives requires different jumpering for Single drive versus Master with Slave present.

Normally, your boot, or "C:" drive will be the master, and the other drive will be the slave.

If the jumpers are correct, then I would suspect the controller circuit on the slave drive. While not common, the drive electronics may have failed.

The best way to check this would be to jumper the drive as a single, connect it as the only drive on the PC.
Then, boot from a bootable DOS floppy, and see if you can access the drive using DOS commands.
dir c: should be enough.

Best Wishes,
Chas

by rcom

Since the drive was working and Chas has as usual explained correctly or most of what to do, I'll take a different approach.

Back in the day Western Digital was the drive of choice and plenty of people did and still feel the same way. But in thelast couple of years I've experienced a high number of these drive failing soon after starting that clunking sound (tech know so well). Western digital has a pretty good no hastle warranty (RMA)policy. Go online answer a few questions and they'll replace it no prob. If you use a credit card they'll send the replacement first and as long as you return the bad drive on time there's no charge. There's diagnostics tools you HAVE to download and run to obtain a failure code. The utility does recoversome of the drives.

Somewhat rare but,
There's a phenom called stiction where the heads get magnetically stuck (not crashed) to the platters. You can often shake that heads free by holding the drive in the palm of your hand and quickly and in a jerking motion spin the drive like turning a door knob. Back in the old days of RFM just to try it I've opened drives and actually rotated the platters to free up the heads. As recent as 6 months ago I had a customer that had this problem for the second time in about a year and by doing what I mentioned both times the drive started up. Since it was a reoccurence, I backed it up, dropped it on the floor a few times and sent it back for warranty exchange.

Good luck!

by freetech

if you haven't changed any settings or configurations before this happened, then your hard drive is bad.
replace it, return it, rma it. it's done.

by mark.hamrick

Hi guys, thanks for all you ideas. Between your ideas and another I found on this site about sticking it in the freezer overnight I have the drive back up and working. Everythings been copied off and I'll be trashing the old drive.
Thanks again...Mark

This discussion is closed to new replies.