Discussion Locked

hard drive not working

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a 30g HD and after a thuderstorm, the computer will not boot with the disk in it. I have put in a new MB, Processor and RAM. Will boot if a different drive. Won't boot even if the drive is a slave drive. BIOS sees it and lists it under the drives but not available as a boot device. Any suggestions?

6 replies

by dmiles

Depending on the operating system will determine how to go about trouble shooting the HD problem.If installed as the master drive the mbr may be corrupt,you will need to try and recover or see the article in TR 200 ways to revive a hard drive

The drive will not boot from the slave drive it boots from the drive that is determine as master,which contains the master boot files.

Also you will need to determine if system bios needs to be flashed

by mikex

Usual Casualties during the Thunderstorm:

MotherBoard
Network Card
Hard Drive
Memory

Figure out for yourself...

by otl

Drive is dead !

Have 60 G with same problem, although it is slaved PC will not boot. Power surge (from turning on the PC) was enough to fry something on the controller card on the HD.

If the data is that important, can try replacing the card. Or take it to a data recovery company. If not get a new HD.

by wlbowers

The hard drive is a casualty.

By your description of the problem it is loading the buss down.

Replace it.

Lee

by glyall

After a thuderstorm (lightening hit)
If the PC does not work it is best to replace the unit. Some part might work, but the parts life are about over.
Hope you got good insurance

Good Luck

This discussion is closed to new replies.