Question Locked

Hard drive reading 0.00MB in CMOS

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My Western Digital 20gig hard drive is not booting. When i go to CMOS setup it shows 0.00MB as Capacity. I am running in Windows XP service pack 2. I tried slaving it on five machines and it still reads 0.00MB. When the machine boots into windows i cannot see the drive. Even when i go to MMC its not there on all five machines. I tried to do an install of XP, 98, 95 and it's not responding. Even when i use boot diskettes.

4 replies

by seanferd

If it shows no capacity in CMOS setup, it's toast.

by skdtech

If you have a copy of Spinrite it may be able to help you recover some data off of it, but even if it managed to save it for a little while I would immediately move all data off of it.

by oh smeg

But before you proceed any further you should test it with WD HDD Diagnostic ToolData Lifeguard Diagnostic it's available here

http://support.wdc.com/product/download.asp?groupid=502&sid=2&lang=en

Of if you don't have a Floppy Drive you can use the CD Version

http://support.wdc.com/product/download.asp?groupid=502&sid=30&lang=en

If the drive fails the first test remove it from that computer and fit to an pother and retest. If it still fails the Drive is Dead and gone to [b]Silicon Heaven[/b] but if it passes the second test either the M'Board, Data Lead or Power Supply in the first computer is dead/damaged and need repairing.

Col

This discussion is closed to new replies.