Discussion Locked

Hard Drive size mismatch

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Looking for some help on an unusual problem. I have a 200 gb WD IDE drive. I was imaging a 80 gb drive to it when I got a general protection fault on my system. Now the 200 gb drive read in cmos and all recovery programs as an 80 gb drive. Anyone have information on how to reset the drive to detect at the proper size?

7 replies

by why me worry?

Irregarless, the true physical size of the drive should not change under the BIOS and should register all available space. The only way this can change is if the drive firmware was overwritten in which the number of heads, sectors per track, and precomp settings were mirrored from the original drive. I've honestly never seen such a problem like yours, but I believe that a low level format may be the only way to fix this.

by chuck0255

I do know the size is wrote on a protected area of the drive. Ghost was what overwrote that area. Its is possible because ghost does a bit copy. Size is not stored in firmware from what I have been able to find.

by deepsand

I suggest the you try the "Questions" forum.

The "Discussion" forum is for matters of general discussion, not specific problems in search of a solution.

Post problems such as this to the "Question" forum, rather than the "Discussion" forum. There are those who specifically seek out problems in need of a solution, and that's where they go to look for such.

Additionally there are the benefits that:

1) The "Questions" forum provides for your feedback, by way of your being able to mark "helpful" responses as such. This does not necessarily mean that a given response contained the complete solution to your problem, but only that it served to guide you toward it. This is intended to serve as an aid to those who may in the future have a problem similar to yours, so that they might have a ready source of reference available, thereby perhaps obviating the need for them to repeat questions previously asked and answered.

2) The revised TR makes it quite difficult to find both "Discussions" and "Questions" that have not had a fairly recent post, owing to some functions comingling them in the listings. By keeping each type in their respective forums, it is easier for all to find what they are looking for.

by chuck0255

Have data on the drive that I do not want to lose. However even deleting the partition still shows the drive size incorrect. Need the help of a recovery expert.

This discussion is closed to new replies.