6 replies
by pgm554
You need to run FDISK from win 98 and enable large disk support.(it should prompt you)
If you use dos 6.22 or below the FDISK util will only see 2 gigs max.
by erng1
by timwalsh
You are correct to be concerned about the amount of space apparently taken up by XP. XP, even if you load EVERYTHING, will not fill 7GB of space.
Couple of things to check:
Go to Control Panel | System properties | Advanced tab | Performance Settings button| Advanced tab | Virtual Memory and check the size of your paging file. The paging file can be configured to allocate the majority of available hard drive space dynamically if needed. It's possible that somehow this setting got changed a fixed size using the majority of your hard drive.
If this isn't the case, you need to explore the contents of your drive to determine what folders and files are taking up so much space.
I have a fairly standard load of XP plus Office 2000 plus numerous other programs (some small, some not so small) loaded in slightly more than 4GB of space.
by thechas
How old is the PC that this drive is in?
Is it possible that the PC does not see the entire drive?
Many older PCs have a 2GB partition limit.
I would start by running fdisk from the W98 startup disk.
Delete the non-DOS partition.
Re-start, and boot from the XP CD.
If you cannot boot from the XP CD, boot from the floppy, run fdisk again, and partition the drive as desired.
Pay close attention to the stated drive size.
If the drive size is 2GB, you have a BIOS hard drive size limit issue.
Re-boot once more, and run setup on the XP CD.
You should be able to install XP with the drive formatted as a NTFS volume.
Chas
by djent
by jim phelps
The following is likely not the solution you need, but it might be. Try the other solutions first, and if none of them work:
I have seen cases where an older computer will not recognize the full capacity of a hard drive. But if it is already FDISKed and formatted at that higher capacity, the older computer WILL recognize the full capacity.
Install the 8GB hard drive in a newer computer, then FDISK and format it there. Then put the 8GB hard drive in the older computer. The older computer will now probably be able to see all 8GB.
Don't run FDISK on the 8GB hard drive while it is in the older computer, though, because you will likely "hose" the "extra" 6GB of the hard drive, making it inaccessible even from the newer computer, even if you run FDISK again from the newer computer.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending