5 replies
by kjhiltz Accepted solution
by ozi eagle Accepted solution
Hi,
You probably have either windows 2000 or XP.
What you need to do is to put the HDD back into the original computer and boot.
Right click on MY COMPUTER and open PROPERTIES - HARDWARE - DEVICE MANAGER.
Go to IDE ATA/ATAPI controllers and delete them all. Shutdown computer DO NOT REBOOT!!!
Place HDD in the new computer and boot, hopefully it will start and look for new drivers for your HDD.
Herb
by mjd420nova Accepted solution
by rkuhn040172 Accepted solution
Do you have the pins jumpered correctly?
As in master vs slave?
Good luck getting the OS from the old PC working in the new PC...ain't going to happen. Too many driver issues to work out.
Best thing to do is either use the 40 GB as a slave drive or backup your data and reformat.
Assuming both drives are the same speed, I'd install the 15 GB as an OS drive and just use the 40GB as a data/programs drive.
by meridenscrafts Accepted solution
hi Not unless you make number two a slave drive. you have to move the jumpers on the hdd
You check and see the diagram on the hard drive ,you need to make one a master and one a slave.
then after you put everything into the number one drive you can format it and change them. around. be sure and reset the jumpers. I did this. put two in one computer. then moved all data to the other drive. took the drive out and reformatted it put it in the new drive reinstalled my windows etc. you do know you have to have windows nt, 2000 before you can put windows xp in. I think someone told me this????
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending