Discussion Locked

Hard Drive will not boot.

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have 2 hard drives; an 8gig on IDE and a 14gig on a Promise ultra 66 card. I want to remove the 8 gig drive to sell to someone. The drive I want has windows already on it and it totally usable but when I try to boot from it, I get a message that says "not a system disk." I tried going into Fdisk and chaging that drive to active, but I get a message that says "only drive one can be made active" There really isnt much on the 8gig drive and I really want to get rid of it. If anyone has any ideasplease let me know.

10 replies

by csmith

To make the 14 Gig drive into the C: drive, (And be able to make it active) the 8 Gig has to be removed from the system. The IDE has to be disabled (for onboard IDE) or the IDE card removed. The Promise card has to be the primary IDE (IRQ 14 etc.),and the BIOS settings have to have the 14 Gig Drive settings.
Boot from a floppy after the work, and make the 14 Gig Drive the Active partition and it should work.
Regards, Chris

by dave5168

Make sure your motherboard is capable of accepting drives larger than 8gb. On some older (3 years is old these days)motherboards 8gb was an unwritten limit and the bios wasn't flashable to increase this value. what is your motherboard brand & model?

by dave5168

Your email said a BH6 Abit board. That would certainly work with larger than 8gb. Re- sys.com the drive and see if it will boot then.

by thedrummer2006

If the only thing you have on the promise card is the 14 gig drive, rip that promise card out and set the jumpers on the back of your drive for Master and put it on the primary side of your IDE controller. Like the other responder said you may have a problem with the fact that this drive is larger than 8 gigs. IF so you can download software that will take care of this problem.
maxtor drives come with this software. I cannot find the site to download it from. Sorry..
Good luck.

by cascom

Couldn't be easier.
Disconnect the other drive,
Boot the system from the install floppy and set the drive as active using fdisk...

This discussion is closed to new replies.