Discussion Locked

hard drive won't boot from floppy

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
A hard drive will not boot even from a floppy. When you turn on the PC Windows95 starts to load and then stops when it gets to "Press F1 to enter setup". I can't get to CMOS or use the keyboard or mouse. I suspect this user may have contracted a virus. Any suggestions on how to boot before I scrap the drive?

12 replies

by dsmartin12

Why can't you get into the CMOS. Have you tried either resetting the CMOS through a Jumper on the motherboard if it has it or by pulling out the battery? Either one of those should clear the CMOSS, then you should be able to go in and set it to bootoff the floppy.

by aqmike

To boot up, you are going to have to reset the CMOS. If it still doesn't work when you reboot, an option may be to try installing another hard drive and make the current drive the secondary drive. Then, you may be able to run a virus program on the bad drive after you have gotten into W95. Hopefully this idea may help you. Good luck.

by steve.weber

This one needs a little more information. When did the problem start, what processor, mainboard, and HDD are involved?

by stillatit

Try the following:

1. Try getting into the CMOS setup during the initial power-on sequence (DEL or F1 or F10 depending on your system). If you cannot do that, the problem is NOT the drive. You can convince yourself of this by unplugging the powerto the drive and trying again.

2. If you cannot get to the setup at all, try resetting the CMOS. This varies by motherboard, but typically it requires shorting a pair of jumpers and rebooting. Find the manual for that board, or look for a jumperpair marked "reset" or similar. If this does not work, it is time to take the system in for repair (or a motherboard replacement).

3. If you can get to setup, set the boot sequence so that the system boots from floppy first, then hard drive. Try to boot from a DOS floppy and see if that works. If it does, and if you can, check the contents of the C: drive using DOS. Note that if you cannot boot from a floppy, again, the problem is NOT the hard drive (since you have not tried to read it at that point). Again, you can convince yourself of this by powering down the hard drive and trying again.

4. If you can boot from a floppy, boot from a Windows boot floppy to the DOS prompt. Run scandisk on C: to verify the integrity of the file system. Run a virus check if you have a scanner on a floppy disk.

Good luck.

by stillatit

If you have a spare power supply, try replacing the power supply before you trash anything. Sometimes a weak power supply will make everything else look bad.

by mike (from canada)

Most computers do not require a floppy disk to boot the hard drive. If you see "Press F1 to enter setup" then that means windows 95 isnt loading at all. If your hard drive and disk drive sound like they are working like they did before then dont blame them. It probably is your cmos configuration. Try entering your cmos and use the default settings by loading the power up defaults or the bios defaults. If that fails, replace your memory. If that fails again, replace your motherboard.

This discussion is closed to new replies.