Discussion Locked

Hard Drives and Windows 95

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Ok, I have a couple questions. First of all, I have a 1.2gb HDD that keeps formatting as a 2.0 somethign MB drive. I tried doing it in both dos and in win95, and both tell me its only that big. and doesnt give me an option to change the size. Just abad drive?

My second is this. I have a 2.0gb drive that was originally in a Mac, but I was told I could format it for a PC. Well, I have done that, and within Win95 it can read the drive... but Win95 set up wont run on it... it stops at the scan disk part, and doesnt scan the drive. Yet the computer doesnt freeze up or anything... how can I use this?

My third is, I have another 2.0gb drive that I am trying to reinstall win95 on for a client. Well, it wont install. I got the install program to run once, and after it was done... nothing was on the drive. How can I actually get it to install and run like it is supposed to?

9 replies

by csmith

On the 1.2 Gig HD the partition table is messed up.
Repartion the HD. (Run fdisk) and it should be OK.
If it is not, download the diagnostic and install software from the manufacturer and Zero Fill the drive as the first step.
If that doesn't work the HD has internal problems. Run the full diagnostic program.

The Mac drive may also have to be Zero Filled to get it to partition and then format properly on a PC.

Regards, Chris

by csmith

Some manufacturers programs do not include Zero Fill.
If you have one that doesn't, the best substitute is the Low Level Format command included in almost all of the manufacturer's disk utilities.

Regards , Chris

by kloran-[thrawn34

How do I Zero Fill? I can do fdisk fine... but I dont have any experiense with Zero Filling. Never had to do it before.

by kloran-[thrawn34

These are all HDD that I have been given, thus I have no software utillities with them at all. The Mac drive is a Western Digital Caviar (sp?) and the 1.2 gb is a Maxtor. I assume I would be better off doing a Zero Fill for all of them, and then a low-level format? Or do them in reverse order?

by sixfourtykilo

Sometimes manufacturers do not include what could pose as damaging utilities as Low-Level-Formatting, although at this point I would highly recommend low-level formatting all three of the drives. Seagate has a formatting utility that will work on most any drive as long as you have the sizes of the Cylinders, Heads, and sectors.

WARNING! You will lost EVERYTHING by performing a low-level format! You will even lose your PARTITION TABLE! The point of the format is to bring your drive back to factory specs.

Good luck and BE CAREFUL!
640k

This discussion is closed to new replies.