Discussion Locked

harddrive

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

have a hardrive MAXTOR UDA 133 has a slight noise on boot up,been to maxtor for there power check diagnostic program, followed all the instructions on how to get it to boot and work,it will boot into the logo screen the thats all,i have been on to maxtor and they say it should work,I am lost now on how it should, the same happen if i try to run the PCCHECK program as well,please forgive the simplicity of ? as new to pc's
my pc specs
mb ABIT KG7-RAID AMD761
HDD MAXTOR 40GB UDA 133
512MB DDRRAM
ATHLON XP 17+1446MHZ SOCKET A PROCESSOR

11 replies

by thechas

Let me see if I understand what is happening.

You boot the system.
There is a noise from the hard drive. (this may be the normal self test for the drive)
You get the Logo screen, and then everything freezes.

If this is the Windows Logo screen, I think it is a OS installation problem, not a hardware problem with the drive.

If you are running W9X or Me, the first thing to try is to reduce memory to under 511MB.
There is a history of Windows lockups with 512 or 1GB of RAM.

The next step, would be to boot from a startup floppy, and re-install the operating system.

Another posability is a hardware conflict.
Try removing all plug in cards except the video card, and then booting.
Remember to switch off, or unplug the power supply before removing any components.

by william jay

If this is a new drive to the system, remove it and check the jumpers for appropriate master or slave setting, and check the 80pin ribbon cable to see that both pins 1 are oriented properly.
On startup, tap the delete key to get to BIOS setup, then run the utility to "auto-detect hard disk" and see that the motherboard finds the drive, and any other drives installed.
These days it's safe to set almost everything to Auto Auto Auto, as the devices are better now at declaring their capabilities, except S.M.A.R.T, which can stop a boot if used improperly, (ask if you need more info).
If this isn't the way to a solution, then likely there is a problem with the OS or software. . cheers.

by otl

Due to your specifications, I believe your problem is;

Two Channels of Bus Master IDE Ports supporting up to four Ultra DMA 33/66/100 devices

Motherboard does not support UDMA 133.

by jean_hera

I aggree with the first answer, this seems to be OS problem, does the booting sequence -memory test hard drive loading exetra... go on then you get the windows log? or it is the PC-maker Logo that hangs??
If it is the windows Logo, then you should consider re-installing windows.

by yacco

If the drive is on one of the raid controllers and you changed ANYTHING in the raid array setup after you installed the operating system you have probably toasted the operating system. If so, make sure you have the array set up like you want it first, then re-install the operating system.

This discussion is closed to new replies.