Discussion Locked

hardware

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I shoped several M720 (Elpina=PCChips) mainboards for maintenance but they hang up at random. I've tried upgrading the Amibios (bios401s.rom) but a can't fix the problem. I've checked the jumper's configuration and everything looks like to be ok.
What else can I do?

9 replies

by thechas

What specific configuration, and problems are you having?

PC Chips primary business is OEM boards, as such, they offer very little support.

I had a M710 that was VERY finicky as to the type of RAM installed.
I ended up having to use some older technology DIMMs to get it to work reliably.

As to BIOS updates, your free options are limited to Elpina or PC Chips.
DO NOT use a BIOS that is not specific for the exact motherboard that you have.

The 3rd party BIOS providers charge around $70 for a new BIOS, so it likely is not worth it unless you have a number of IDENTICAL boards.
If so, try www.unicore.com for custom BIOS updates.

What CPU are you using?
I believe that the chip-set only supports PII up to 450MHz, and Celeron upto 600MHz.
The Celeron CPUs below 850MHz use 66MHz RAM and FSB settings.

Chas

by aeinformatica

Well, M720 is PCChips, as we Knew already. These models of Mb suport sdram dimms up to PC100. I've tried several working without errors on other boards. CPUs can be used up to 333 Mhz. I've tried Intel celleron 300A & 333, PII 300 & 350 (fsb 100).
Thank You, anyway.
JR

by csmith

This is not a BIOS problem.
This usually is a RAM problem.
RAM comes in three grades.
With these mainboards, stay away from the cheap stuff.
(I am assuming the PS is also of decent quality.)
Regards, Chris

by aeinformatica

IBM ram chips are suposed to be reliable chips, specially if assembled in the U.S.A.. Kingston still is "value ram"!
Thanks.
JR

by colin_mendonca

the possible reason could be the type of RAM installed or the amount of RAM installed is not according to the specifications.check your motherboard manuel for details.

by csmith

If it is IBM RAM, it is not the RAM.
The next most common problems are viruses and power problems.
I am assuming you are testing these motherboards with only the video, keyboard, hard disk, and floppy engaged, and no power management.
If not, troubleshooting is a lot more complex.
Regards, Chris

by aeinformatica

Was it. I Was using several new 235W power supplies, usually used with PII. Because of these three reasons I have never asked myself that question.I replaced all of them by the 350W ones and everything runed ok.
Thank you very much.
JR

This discussion is closed to new replies.