Discussion Locked

Hardware (hard drive) Migration

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have physically removed a hard drive with information on it that I want to preserve from an old machine that has since been destroyed into another but it will only boot in safe mode. I would like to be able to run all programs and the like on new system. What are the proper steps to take?

2 replies

by thechas

First, Windows does not take well to being moved to different hardware.
You are best off to remove ALL devices from device manager before shutting down the old system for the last time. Then, move the drive to the new hardware.

Which version of Windows?

For W95, 98 and Me, you may only need to install drivers.

For W95, if the new CPU is an AMD and is faster than 350MHz, you need to install a patch from Microsoft to overcome an error.
Also, W95 does not work well with some Intel Pentium 4 chip-sets.

For W98, if the CPU is faster than 2.1 GHz and you have certain networking options enabled, you can have problems. So far, the only fix for this is a slower CPU.

For Windows NT, you usually need to reinstall NT clean on the new hardware.

For Windows 2000 and XP, you usually have problems unless the hardware is NEARLY identical.

Start by examining the legacy system files:
Autoexec.bat
Config.sys
Sys.ini
Win.ini
Back up the files, and remove ALL hardware drivers in these files.
For "most" versions of Windows, you can run sysedit from the run box on the start menu.

For Windows 95, 98 or Me, boot from a startup disk and reinstall Windows.
The registry and programs should remain intact.

For Windows NT, you can try removing devices from device manager and allow Windows to find devices when you re-boot.

For Windows 2000 and XP, re-installing wipes out the registry.
Thus, Windows will not recognize ANY installed applications.
Try booting from the OS CD, and running recovery console.

Chas

This discussion is closed to new replies.