Discussion Locked

Hardware install

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi, if I install a CD burner, what do i have to do to have it copy a source cd from the cd-rom, as far as wiring or jumper selection is concerned. Thanks!!
Steve Kerpics

5 replies

by dmiles

Concerning the jumper settings,let cd-rom remain as the slave on the Primary Controller with Hard drive and then set the cd burner as the Master on the Secondary controller,(this is if you only have one hard drive),with two hard drives set the jumpers as Slave
Now depending on the software that you are using to copy
1)Insert the source cd in the cd-rom
2)Insert the blank in cd-rw and then you will need to use the software program that is loaded on the machine
I am using NTI CD maker,a screen interface will open,then I can follow the screen instructions to copy cd.

by chef50

Thanks for the help. It seems to have done the trick!!!...You guys are GREAT!!!!
Thanks again, Steve.

by rogerndgreen

As fara as the above answer goes, I hope that you HAVEN'T got a CD as a slave on the primary channel! This is because each channel will only go as fast as it's slowest device, so if you have got an ATA66 or 100 hard drive, putting a CD on the same channel will slow it down.

I would suggest that you have your hard disk (or disks) on one channel, and the two CDs on the second. Leave your CD-R as Master, and install the CD/RW as a slave (if you are using IDE). Me - I use SCSI, which lowers the hit on the CPU - as well as offering more flexibility when it comes to adding different speed devices (but that's my preference).
As far as software goes, I use Adaptec EasyCD 5, but Nero is just as capable, if not more. You tend to use what youlike.

Roger

by chef50

Thanks for the help Roger, I'am new to all this . Somethings I can figure out but this had me baffled.
Thanks again, Steve.

This discussion is closed to new replies.