3 replies
by mrafrohead
First, the BIOS sees the drive there, but it appears smaller than it is. Is this hard drive the same hard drive that you had in the computer before it broke, or is it a different hard drive. Reason: BIOS may not be able to read the full size of the hard drive.
As for Fdisk. When you tried to run it, go into option 4 and verify how many partitions there are on the disk, and also what their status is.
IF YOU CHANGE THE PARTITION TABLE, YOU ARE GOING TO HAVE A MUCH HARDER TIME RECOVERING ANY LOST DATA!!!! Be very sure that you absolutely have to fdisk the computer before you do it.
Worse comes to worse, there is data recovery software that you can run in dos mode, use your boot disk and then run the program, and that will recover the data that is on the disk, and you can move it to another drive.
Anywho, please let me know these few things, and I'll see if I have any advice for you that may be worth your time;)
mrafrohead
by electronx
by blue.sun
If fdisk shows no active partitions ,then a)- the partition table is a goner (hope not!) b- DOS does not recognize your file system . It can happen if you're running an older version of fdisk ,it may have trouble reading fat32 or NTFS partitions.
Anyway,if the HD is IDE why don't you connect a bootable HD as master and the faulty HD as slave ,you boot up from the first drive and can explore the second . Make sure that the partition types are the same or at least compatible ,otherwise you won'tbe able to see the faulty HD from the master.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending