15 replies
by kennethaj
by mhoward
You simply need to remove the cover, unscrew the hdd, unplug the cable, verify if the master, slave, cable select jumper is switched properly (like the old HDD), and assemble all again.
The bios setup should recognize the new hdd (verify that the automatic selection under bios is enabled), then boot with a diskette, fdisk the drive, assign an activa partition and the format the new drive.
Hope it helps!!
by mhoward
by mhoward
by mhoward
check out this link.
If it doesn't wotk I found it on toshiba.com,
technical support center , userguide (way to the botom)
Hope the info is there.
Leopold
The filename is:
s162ug32.exe
by mhoward
I'm the document LOL.
Here is what you do.
Step 1: Turn everything connected to your computer and your computer off
Step 2: remove the case. (you will probably need a phillips screwdriver for this)
Step 3: Remove the screws attached to the hard drive. Check to see if there are screws underneath and remove them as well.
Step 4: Pull out the hard drive.
by mhoward
by mhoward
by mhoward
I recently needed to change a hard drive in a Toshiba laptop, but did not want to take out every screw just to find it. I called Toshiba, because their website was of no help. The technician did not have the specs on the laptop either, but did give me the phone numbers of several local Toshiba authorized service centers. I called one and asked him for help. Since it was a quick, simple question, he was happy to help and did not charge me.
If you have only a couple of questions, you may want to give it a try. You've got nothing to lose.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending